ALPATEC AC 9E Mode D'emploi page 14

OPERATION INSTRUCTION
STARTING:
Plug in the unit, a sound « bip » is heard.
Press button M/A (I), the unit starts setting the last used parameters (mode, temperature and fan speed).
LED screen (E) displays the surrounding temperature.
SELECTION OF THE MODE:
Press button MODE (L) to change the mode.
Each time, function changes according to following diagram: COOLING -> DRY -> FAN ONLY -> COOLING.
ADJUSTMENT OF THE TEMPERATURE:
Use + / - (M) touches to set temperature.
One pressure increases or decreases temperature by 1°C.
Temperature is displayed on LED screen (E).
A few seconds after, surrounding temperature will be displayed again.
Temperature range is from 16°C to 31°C.
ADJUSTMENT OF THE FAN SPEED:
Press VITESSE (J) touch to adjust fan speed.
Each pressure, fan speed changes according to following diagram: LOW -> MEDIUM -> HIGH
DRY MODE.
During the dry operation, the fan speed cannot be adjusted. Low speed will be set automatically.
It is no use adjusting temperature; it will have no effect on the drying way.
FAN ONLY MODE.
It is no use adjusting temperature.
STOP:
Press M/A (I) touch to stop the unit.
A sound can be heard and the unit stops running.
All lights switch off.
TIMER:
To turn on the unit automatically, press TEMPS (K) touch when unit is plugged but not running.
Set remaining time before starting using + / - (M) touches. Each pressure adds or removes half an hour,
from 0.5 to 10h and one hour from 10h to 12h.
(A) light switch on.
Remaining time before starting is displayed on LED screen (E).
To turn off the unit automatically, press TEMPS (K) touch when unit is plugged and running.
Set remaining time before stopping using + / - (M) touches. Each pressure adds or removes half an hour,
from 0.5 to 10h and one hour from 10h to 12h.
(A) light switch on.
Remaining time before stopping is displayed on LED screen (E) and after a few second, room
temperature is displayed again.
To cancel the timer, press TEMPS again and set 00:00 time.
14