Mitsubishi Electric City Multi PLFY-WP VFM-E Série Manuel D'utilisation page 12

3. Operation
Direct/Indirect setting
: Direct
: Indirect
: Indirect
: Direct
Select:
Angle
Outlet
F1 F2 F3 F4
i-See button (Wireless remote controller)
1 Each time is pressed during operation, the setting changes in
Display
Setting OFF Direct
When the setting is changed from OFF to Direct or Indirect, the vane
setting changes to "Auto". This setting is applied collectively to all of the
vanes.
3.6.3 Energy saving option
Energy saving option
No occupancy energy save
Room occupancy energy save
No occupancy Auto-OFF
Setting display:
Cursor
F1 F2 F3 F4
12
3 When Direct/Indirect is selected,
set each air outlet.
Select the air outlet with the [F1] or
[F2] button, and change the setting
with the [F4] button.
After changing the settings for all of
the air outlets, press the [SELECT]
button to save the settings.
* In order to enable this function,
the airflow direction must be set
to "Auto".
Indirect
1 Select the desired menu with the
[F1] or [F2] button.
No occupancy energy save
If there are no persons in the room
for 60 minutes or more, energy-
saving operation equal to 2 °C is
performed.
Room occupancy energy save
If the occupancy rate decreases
to approximately 30% of the
maximum occupancy rate, energy-
saving operation equal to 1 °C is
performed.
No occupancy Auto-OFF
If there are no persons in the
room for the set amount of time
(60–180 minutes), the operation
is automatically stopped.
Energy saving option
No occupancy energy save
Cooling/Heating
Select:
F1 F2 F3 F4
Energy saving option
Room occupancy energy save
Cooling/Heating
Select:
F1 F2 F3 F4
Energy saving option
No occupancy Auto-OFF
120 min.
Select:
Time
F1 F2 F3 F4
18:47 Thu
Shut down by
No Occupancy Auto-OFF
31/Dec AM12:59
F1 F2 F3 F4
2 When No occupancy energy save
or Room occupancy energy save
is selected
Select the setting with the [F4]
button.
OFF Cooling only Heating
only Cooling/Heating
After changing the setting, press
the [SELECT] button to save the
setting.
OFF: The function is disabled.
Cooling only: The function is
enabled only during cooling mode.
Heating only: The function is
enabled only during heating mode.
Cooling/Heating: The function is
enabled during both cooling mode
and heating mode.
3 When No occupancy Auto-OFF is
selected
Set the time with the [F3] or [F4]
button.
(the operation will not stop
automatically).
60 – 180: The time can be set in
10-minute increments.
4 The message at left will appear
if the operation was stopped
automatically by the No occupancy
Auto-OFF setting.