Specifications - Sony MDS-JA333ES Mode D'emploi

Message Meaning
You tried to start Program Play when
No Program!
no program exists.
An attempt was made to record to a
Premastered
premastered MD.
The program contains the maximum
ProgramFull number of tracks. You cannot add any
more tracks.
The MD is being controlled by an
REMOTE
external device connected to the deck.
You attempted to perform another
operation while in S.F Edit (changing
the recording level after recording,
S.F Edit!
Fade-in, Fade-out) mode.
You cannot perform any other
operations while in S.F Edit mode.
The Smart Space Function is on
Smart Space
(page 19).
The deck is checking the TOC (Table
TOC Reading
Of Contents) on the MD.
1) If "REMOTE" appears under other circumstances, turn off
the deck, then turn it on again.
50
GB

Specifications

Specifications
System
Disc
Laser
Laser output
1)
Laser diode
Revolutions (CLV)
Error correction
Sampling frequency
Coding
Modulation system
Number of channels
Frequency response
Signal-to-noise ratio
Wow and flutter
Inputs
ANALOG IN
DIGITAL IN OPT1
DIGITAL IN OPT2
DIGITAL IN COAXIAL
MiniDisc digital audio system
MiniDisc
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
1)
MAX 44.6 µW
1) This output is the value
measured at a distance of
200 mm from the objective lens
surface on the Optical Pick-up
Block with 7 mm aperture.
Material: GaAlAs
400 rpm to 900 rpm
ACIRC (Advanced Cross Interleave
Reed Solomon Code)
44.1 kHz
ATRAC (Adaptive TRansform
Acoustic Coding)/ATRAC 3
EFM (Eight-to-Fourteen
Modulation)
2 stereo channels
5 to 20,000 Hz ±0.3 dB
Over 100 dB during play
Below measurable limit
Jack type: phono
Impedance: 47 kilohms
Rated input: 500 mVrms
Minimum input: 125 mVrms
Connector type: square optical
Impedance: 660 nm (optical wave
length)
Connector type: square optical
Impedance: 660 nm (optical wave
length)
Jack type: phono
Impedance: 75 ohms
Rated input: 0.5 Vp-p, ±20 %