Perel E305W2 Mode D'emploi page 2

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
•
Indoor use only.
•
Keep the device away from children and unauthorised users.
•
Do not connect to an appliance with a load exceeding the capacity of the timer (see Technical
Specifications).
•
Do not use a timer to control an appliance containing a heating element (cooking appliance, heater, iron...).
•
Never leave the appliance unattended while in use.
•
Always make sure the plug of the connected appliance is fully inserted into the timer.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
3. Operation
3.1 Setting the day and time
1. Unplug the timer from the outlet.
2. In Clock mode, press and hold OK for 4 seconds. The weekday flashes.
3. Press button +1 or -1 to select the day of the week and press OK to confirm. The hour digit flashes.
4. Press button +1 or -1 to adjust hour and press OK to confirm. The minute digit flashes.
5. Press button +1 or -1 to adjust the minutes. minute and press OK to confirm.
6. Press MENU to finish. The display shows the newly set time. The hour display is in 24 hour format.
Notes
•
To change the hours and minutes more quickly, press and hold +1 or -1 for more than 1 second. The
number will change quickly in ascending or descending order. Then release the button until your desired
number shown.
•
If you want to exit the clock setting mode, press MENU.
3.2 Setting a program
1. Unplug the timer from the outlet.
2. To enter PROGRAM mode, press MENU. PROG 1, ON flashes.
PROG 1 shows the program number, ON or OFF shows the program status.
3. Press +1 or –1 to select a program number and a status.
The default program is 1 ON, press +1 to select program 1 OFF, press +1 again to select program 2 ON,
and so on.
4. Press OK. The weekdays are flashing.
5. Press +1 to select a day or set of days.
6. Press OK to confirm. The hour digit flashes.
7. Press +1 or –1 to set the hour and press OK to confirm. The minutes digit flashes.
8. Press OK to confirm. Press MENU twice to exit program mode.
V. 01 – 14/07/2015
E305W2 - E305W2-G
USER MANUAL
2 ©Velleman nv