Fuelling; Fuel Fuel Information; Starting / Stopping The Engine; Half Throttle Start Position - Solo 137SB Instructions D'emploi

Fuelling; Starting / Stopping the engine

5. Fuelling

5.1 Fuel Fuel information

A high performance two-stroke engine operated with
a petrol:oil mixture (petrol + oil = fuel mixture) or with
a special fuel mixture for two-stroke engines
available from specialists powers this machine.
We recommend the proprietary "Aspen 2-takt"
special fuel mixture. Please observe the special fuel
manufacturer's instructions.
Information on individual mixing of the fuel mixture
Normal or super unleaded petrol can be used for
individual mixing purposes (minimum octane
number 92 RON).
When using a particularly high quality proprietary 2-
stroke engine oil such as the "SOLO Profi 2T-
Motoröl" which we supply, we recommend an
oil:petrol mixing ratio of 1:50 (2%).
When using other brands of 2-stroke oil we
recommend a mixing ratio of 1:25 (4%).
Only use proprietary 2-stroke engine oil!
Never store fuel mixture longer than 3 - 4 weeks.
Fuel mixture table
Petrol in
litres
SOLO 2T
engine oil
2% (50 : 1)
1 0.020
5 0.100
10 0.200
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and avoid
inhaling petrol fumes - health hazard!
5.2 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off. Carefully
clean the area around the filler inlet. Place the
machine with the fuel inlet pointing upwards.
Unscrew the tank lid and fill the fuel mixture up to the
lower edge of the filler neck. Use a funnel with filter
to prevent tank contamination. After filling the tank
replace the tank lid and tighten firmly.
ENGLISH 12
Oil in litres
Other two-
stroke oils
4% (25 : 1)
0.040
0.200
0.400

6. Starting / Stopping the engine

6.1 Half throttle start position

Fig. 11
• Grip the handle; the safety locking key (3) is
activated via the grip area, which also enables
throttle lever (2) to be regulated.
• Press throttle lever fully down.
• Whilst holding the throttle lever down, move stop
switch (1) towards "Start"
throttle lever.
The part throttle stop is cancelled by brief operation
of the throttle control.

6.2 Choke and primer

Fig. 12
Adjust choke as follows:
• With a cold engine, position choke lever (7) up
towards "Close" .
• With a warm engine, position choke lever (7)
down towards "Open"
When first starting or if the fuel tank has been
completely drained and has been refilled, press
primer (8) several times (at least 5x) until the fuel is
visible in the plastic bulb.
Press the decompression valve (6) every time
before pulling on the starter handle to make the
startup process easier. After starting, the
decompression valve automatically returns to its
normal position.
( )
, and release the
.