Summer Infant 12636 Mode D'emploi page 3

USE:
Place the assembled bedguard on to the bed frame (mattress base). Adjust the length of the legs so that the side, when in the locked (upright)
position, touches the side of the mattress, with the legs fitting snugly against the other side of the mattress. For smaller mattress sizes, you may
need to move the plastic leg supports to allow for the full range of adjustment
If the mattress base is level with the side of the bed, the fitted bedguard should look like this:
If the mattress base is below the sides of the bed, you will need to adjust the legs to allow the assembled bedrail to fit between the bed sides.
The fitted bedguard should look like this:
NEVER use the bedrail with the end of the legs removed. All parts must be used and correctly assembled.
To fold the bedrail side down, grasp the ends of the bedrail and use your fingers to press the buttons on both hinges; rotate the bedrail down until
it locks in the folded position. To raise the bedrail side, press the buttons on the hinges and rotate upwards. The hinge locks will engage
automatically, but always check they are secure (Figure N).
TO CLEAN:
To clean the bedguard, wipe the surface with a damp sponge, mild detergent, and cold water. Lay flat to dry.