Kicker KXM.5 Série Manuel D'utilisation page 8

All level matching circuitry in the KXMA amplifi ers is at the beginning of the signal chain. If you are going
to use features like bass boost, SHOCwave or EQ settings, it may be necessary to readjust the gain to a
lower setting to compensate for increased output at those frequencies.
Once the amp and source unit are gain matched, you will want to make certain you are not overdriving
your speakers. Use the following procedure:
1. Set the source until volume to 0.
2. Reconnect the speakers to the KXMA amplifi er.
3. Slowly increase the volume level of the source unit as you listen for audible distortion.
4. If you can hear clipping, decrease the gain of the amplifi er until it is gone.
KMBLC REMOTE BASS INSTALLATION
Remote cable passes audio; do
not run cable parallel to power
wires.
8
2021 KXMA 5ch Amps Rev D.indd 8 2021 KXMA 5ch Amps Rev D.indd 8
REMOTE BASS
Connect the cable to the KMBLC remote and the Remote
Bass connection on the amplifi er
Surface-mount the KMBLC remote
using the supplied screws.
back view
2/8/2021 1:21:51 PM 2/8/2021 1:21:51 PM