Publicité
Les langues disponibles
Les langues disponibles
MODEL:
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN
A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM
TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR
COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4 INCHES (10CM) OPEN
VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM)
CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
PERFORMANCE
Model:
RMS Power, AMP1 and AMP2
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω bridged mono, ≤ 1% THD+N
RMS Power, SUB channel
@ 14.4V, 1Ω mono, ≤ 1.5 % THD+N
@ 14.4V, 2Ω mono, ≤ 1.5 % THD+N
@ 14.4V, 4Ω mono, ≤ 1.5 % THD+N
Length [in, cm]
Height [in, cm]
Width [in, cm]
Frequency Response [Hz]
Signal-to-Noise Ratio [dB]
1W Signal-to-Noise Ratio [dB]
Input Sensitivity
Selectable Electronic Crossover
KickEQ™ Parametric Bass Boost
Subsonic Filter
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of
open ventilation for the amplifi er. Drill four holes using a 7/64" (3mm) bit and use the supplied #8 screws
to mount the amplifi er.
2
2021 KXMA 5ch Amps Rev D.indd 2
2021 KXMA 5ch Amps Rev D.indd 2
KXMA.5-SERIES AMPLIFIERS
OWNER'S MANUAL
KXMA900.5
KXMA900.5
75W x 4
125W x 4
250W x 2
400W x 1
400W x 1
200W x 1
12-3/4, 32.4
2-1/8, 5.5
8-5/16, 21
AMPS 1-2: 10Hz–20kHz
SUB: 20Hz–160Hz
>95dB, A-weighted, re: rated power
-75dB
Low 125mV – 5V
Hi 250mV – 10V
AMP 1: OFF/HP/LP, variable 10–5,000Hz with 10X
switch; 24dB/octave
AMP 2: OFF/HP/LP/BP, variable HP 10–500Hz,
variable LP 40–5,000Hz with 10X switch; 24dB/octave
SUB: Variable LP 40–160Hz; 24dB/octave
Boost - Variable 0-6db; Center Frequency - 40Hz
Variable 10–80Hz; 24dB/Octave (sub channel only)
2/8/2021 1:21:47 PM
2/8/2021 1:21:47 PM
Publicité
