Makita TD091D Manuel D'instruction page 6

Reversing switch action
A
1
013529
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1. Reversing
switch lever
B
9 mm
(3/8")
1
2
013530
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and
the bit will not be secured. In this case, try re-
inserting the bit according to the instructions above.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
OPERATION
013532
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the figures.
Standard bolt
.
N m
(ft.lbs)
.
80N m
(58)
.
60N m
(43)
10mm(3/8")
.
40N m
(29)
.
20N m
8mm(5/16")
(14)
0
1.0S 2.0S 3.0S
Fastening time
013576
6
1. Bit
2. Sleeve
12mm(1/2")
12mm(1/2")
10mm(3/8")
8mm(5/16")
(S)