Publicité
Les langues disponibles
Les langues disponibles
English
outward, turn tracking adjustment knob
counterclockwise if belt runs inward.
Belt life will be greatly increased by keeping the tracking
adjustment set properly. To prevent the sanding belt from
rubbing against the sander housing, keep the edge of
the belt about 7/64" (2.7 mm) to 13/64" (5.1 mm) from
the housing.
Fig. E
Changing The Sanding Belt (Fig. F, G)
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of injury, make sure belt
is installed with arrows in proper direction of rotation.
Failure to do this could result in the belt unraveling
creating a hazardous condition.
Pull the sanding belt lever
7
the tension on the sanding belt. Pull the sanding belt from
the two rollers. Put the new 3" x 21" (75 x 533 mm) sanding
belt in position on the front and rear rollers (Figure G).
Ensure that the arrows on the sanding belt and on your belt
sander are pointing in the same direction. Push the lever to
the rear to tension the sanding belt
Fig. F
6
9
clockwise and
9
shown in Figure F to release
7
Fig. G
Dust Collection (Fig. H)
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Fire hazard. Collected sanding dust from
sanding surface coatings (polyurethane, linseed oil,
etc.) can self-ignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
WARNING: Fire hazard. When sanding wood that
could contain nails, or when sanding metal surfaces,
do not use the dust bag or a vacuum cleaner because
sparks are generated. Wear safety glasses and a dust
mask. Due to the danger of fire, do not use your belt
sander to sand magnesium surfaces. Do not use for
wet sanding.
When using your belt sander, dust and grit are produced.
It is important to use a dust bag. Connect the dust bag
by sliding the plastic opening of the bag down over the
dust exhaust port
10
of the sander. To empty the dust
bag, remove it from the sander and unzip the bag over a
trash container.
Fig. H
11
10
11
Publicité
