LG WM2601H Série Guide De L'utilisateur Et Directives D'installation page 26

C A R E A N D C L E A N I N G
REGULAR CLEANING
Removing the Stain in Door Seal
NOTE: Wear rubber gloves and eye protection while
performing the following procedure:
1 Dilute 3/4 cup (177 ml) liquid chlorine bleach with
1 gallon (3.8 L) of warm/hot water.
2
Use this solution to wipe down all surfaces of the
gasket to remove the deposits that are causing any
odor. (Be sure to fold back the lip of the gasket to get
under the edge where residue can build up.)
3
Wipe the gasket with a dry cloth.
4
Leave the door open to allow the gasket to dry
completely.
Do not use undiluted bleach as this will damage the
gasket.Follow the manufacturer's instructions for proper
use of bleach.
If the gasket cannot be cleaned properly, it should be
replaced.
Storing the Washer
If the washer will not be used for an extended period of
time and is in an area that could be exposed to freezing
temperatures:
1
Turn off water supply tap.
Disconnect hoses from water supply and drain
2
water from hoses.
Plug the power cord into a properly grounded
3
electrical outlet.
Add 1 gallon of nontoxic recreational vehicle (RV)
4
antifreeze to the empty wash drum. Close door.
Select the spin cycle and let washer spin
5
for 1 minute to drain out all the water.
NOTE: Not all of the RV antifreeze will be expelled.
Unplug the power cord, dry the drum interior with a
6
soft cloth, and close the door.
7 Remove the inserts from the dispenser. Drain any
water in compartments and dry the compartments.
8
Store the washer in an upright position.
9 To remove the antifreeze from the washer after
storage, run washer through a complete cycle
using detergent. Do not add laundry!
26
(cont.)
Removing Lime Buildup
If you live in an area with hard water, lime scale
can form on internal components of the washer.
Use of a water softener is recommended in areas
with hard water. If a descaler is used, make sure
that it is suitable for use in a washer, and run the
TUB CLEAN cycle before washing clothing.
Lime scale and other spots may be removed
from the stainless steel drum using a stainless
steel cleaner. Do NOT use steel wool or abrasive
cleansers; they can damage the surface.
Notice of tub clean activation
To clean up the tub, please select the tub clean
course. Please empty the tub and insert bleach
into the detergent dispenser and push the tub
clean button.
If you see the shown when you push the
power button and turn it on, it indicates a point of
time to clean tub, therefore operate TUB CLEAN
by pushing the TUB CLEAN button.
If you want to skip the TUB CLEAN, turn the
CYCLE SELECTOR KNOB or push option buttons
to select desired cycle. In this case, you would
see the message again until few washing times
and it would be disappear until next point of time
to clean the tub. Normally you would see the
around every 30 times of usage of a
washing machine.
Door open recommended
It is recommended that you should leave the door
open after getting finished with laundry to keep
the tub clean.