SEVERIN KS 9838 Mode D'emploi page 13

Energy saving tips
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ Do not expose the appliance to direct sunlight, and
do not position it next to any heat sources (radiators,
cookers etc). If this cannot be avoided, however, suitable
insulation must be installed between the heat source and
the unit.
∙ Do not cover the ventilation openings and grilles, and
ensure suffi cient air circulation behind the unit.
∙ The compressor (at the rear) should be cleaned at
regular intervals. Accumulated dust causes an increase in
energy consumption.
∙ Warm food should be allowed to cool down before it is
stored inside.
∙ Do not leave the fridge door open for too long when
loading or taking out food.
∙ Do not set a lower-than-necessary temperature. For
detailed information on the temperature settings, please
refer to the section Temperature control.
Problem
The appliance is not
working at all.
The normal operating
sound changes or
becomes louder.
Transporting the appliance
To prevent damage to the unit during transport, ensure that
all accessories and components inside and around the
appliance are securely fastened.
The unit must only be transported in its vertical position; do
not tilt any more than 30°.
Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
If the unit has been tilted more than 30° during transport,
allow it to stand in an upright position for at least 4 hours
before it is connected to the mains.
Disposal
Devices marked with this symbol must be
disposed of separately from your household
waste, as they contain valuable materials which
can be recycled. Proper disposal protects the
environment and human health. Your local authority or
retailer can provide information on the matter. The
refrigerant and the chemical agent in the insulation foam
must be disposed of through a competent agency. Take
special care not to damage the cooling circuit before the unit
is handed over for competent disposal.
Possible cause and solution
∙ There is a power failure.
∙ The main fuse has blown.
∙ The temperature control is set to '0'.
∙ The fuse in the wall socket (if applicable) has blown. This can be checked by connecting another
electrical device to the socket and checking for function.
∙ Check for proper positioning (uneven fl oor?).
∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing them to vibrate?)
∙ Are there any objects on top of the unit which might be vibrating?
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
∙ caused by the
electrical motor within
the compressor
assembly; during
compressor start-up
the sound level will
be slightly higher for
a limited period of
time.
∙ caused by the cooling agent fl owing through the circuit.
The following table lists possible malfunctions and their
probable causes and solutions. In the event of operational
problems, check fi rst whether a solution can be found using
this table. If the problem persists, disconnect the appliance
from the mains power and contact our Customer Service
Department.
Guarantee
This product is guaranteed against defects in materials
and workmanship for a period of two years from the date
of purchase. Under this guarantee the manufacturer
undertakes to repair or replace any parts found to be
defective, providing the product is returned to one of our
authorised service centres. This guarantee is only valid
if the appliance has been used in accordance with the
instructions, and provided that it has not been modifi ed,
repaired or interfered with by any unauthorised person, or
damaged through misuse.
This guarantee naturally does not cover wear and tear, nor
breakables such as glass and ceramic items, bulbs etc.
This guarantee does not affect your statutory rights, nor any
legal rights you may have as a consumer under applicable
national legislation governing the purchase of goods. If the
product fails to operate and needs to be returned, pack it
carefully, enclosing your name and address and the reason
for return. If within the guarantee period, please also provide
the guarantee card and proof of purchase.
13