Winding The Bobbin; Inserting The Bobbin - SilverCrest SNMD 33 A1 Instructions D'utilisation Et Consignes De Sécurité

Getting ready

Winding the bobbin

Inserting the bobbin

1
3
5
A
6
78 GB / IE
2
4
7
Place the felt cushion (h) on the left
thread spool pin (15). Place the spool of
h
thread (m) on the same thread spool pin
(15).
Guide the thread from the spool into the
thread guide (2), and up to the bobbin.
Pull the thread from the inside through a
hole of the empty bobbin (g). Place the
spool on the spool holder (14) and then
push to the right into the filling position.
Hold the end of the thread. Press the
pedal (r). Release the pedal (r) after a
few turns. Release the thread and cut as
close as possible to the spool. Press the
pedal (r) again.
Once the spool is full, it rotates more
slowly. Release the pedal (r). Replace the
bobbin (g) into sewing position and
remove it.
Note:
If the bobbin winder spindle (14) is in
the winding position, the sewing
process is automatically interrupted.
To sew, push the bobbin winder
spindle (14) to the left (sewing position).
Important:
A Turn power switch (20) to off ("O").
When inserting or removing the bobbin (g),
the needle must be fully raised.
1. Open the hinged cover.
2. Pull the bobbin case tab (A) and
remove the bobbin case.
3. Hold the bobbin case with one hand.
4. Insert the bobbin (3) so that the thread
runs in a clockwise direction (arrow). (4)
5. Pull the thread into the slit and under
the tension spring.
6. Hold the bobbin case between the
index finger and thumb on the bobbin
case tab (A).
7. Insert it into the shuttle race.
Note :
The method of bringing up the lower
thread is explained on page 80.