Alto Professional TMX80DFX Guide D'utilisation Rapide page 5

33. POWER SWITCH - Turns the main
power ON and OFF.
34. SPEAKER JACKS - These jacks are
used to connect to speakers.
Note: In order to avoid damage to the
built-in amplifier, please pay attention to
the allowed impedance of the speaker.
Very low load impedances may damage
amplifier. The minimum load impedance
of L and R channels is 4 ohm respectively.
35. AC Input with FUSE Holder - Standard IEC receptacle, connect your unit to mains with the supplied
power cord.Please check the voltage available in your country and how the voltage for your unit is
configured before attempting to connect your unit to the main AC.
EFFECTS PRESET LIST
No.
00~09
10~19 Echo+Verb
20~29 Tremolo
30~39
40~49
50~59
60~69
70~79 Small Room
80~89 Flanger+Verb
90~99 Large Hall
Preset
A delay effect, simulating the reflection of
Echo
a sound.
Echo with Room effect.
Amplitude modulation of the signal.
Simulate the transducers sound like
Plate
classic bright vocal plate.
Recreate the illusion of more than one
Chorus instrument from a single instrument
sound.
Simulate a small space with slight decay
Vocal
time.
Simulate the sound effect achieved by
Rotary rotating horn speakers and a bass
cylinder.
Simulate a bright studio room.
Simulate to play with another person
carrying out same the notes on the same
instrument and reverb.
Simulate a large acoustic space of the
sound.
34
34
Description
5
33
35
Parameter
Delay Time :
145~205ms
Delay Time :
208~650ms
Decay time : 1.7~2.1s
Rate : 0.6 Hz~5 Hz
Decay time:0.9s~3.6s
Rate : 0.92Hz ~1.72Hz
Rev. decay time:
0.8~0.9s
Pre-delay: 0~45ms
Modulation depth :
20%~80%
Decay time : 0.7~2.1s
Pre-delay : 20~45ms
Decay time : 1.5~2.9s
Rate : 0.8Hz ~2.52Hz
Decay time : 3.6~5.4s
Pre-delay : 23~55ms