Monacor TXA-800R Mode D'emploi page 8

GB The receiver can be combined with the fol low -
ing MONACOR transmitters:
Unit
TXA-800ST
TXA-802CD
TXA-800HSE pocket transmitter
TXA-800HT
ATS-16T
4 Inserting (Rechargeable) Batteries
1) Slightly press down the marked area on
the battery compartment cover (10) while
removing the cover in a downward move-
ment at the same time.
2) Insert two (rechargeable) batteries of size
AA into the battery compartment. Observe
the correct polarity (→ imprint in the com-
partment).
3) Replace the cover and lock into place.
For quick and easy charging of the batter-
ies used in TXA-800R and TXA-800HSE,
MONACOR offers special chargers:
TXA-800PS (order number 25.2140)
charging station for charging the batteries
of up to 2 units at the same time
TXA-12C (order number 25.2150)
transport case for charging the batteries of
up to 12 units at the same time
TXA-36C (order number 25.2160)
transport case for charging the batteries of
up to 36 units at the same time
8
Type
mains-operated
transmitter
battery-operated
active speaker system
with transmitter
hand-held microphone
with transmitter
pocket transmitter
5 Operation
1) Connect the earphone supplied (ES-16,
also available as a separate item) to the
Order No.
jack EAR. (1) and fasten the earphone to
your ear.
17.2600
For reproducing the sound via an am -
plifier system, connect the input of the am-
plifier via a 3.5 mm plug to the jack AUX
17.2240
OUT (5).
2) Advance the control VOL. (3) in clockwise
17.2250
direction until the receiver is switched on.
When it is switched on, the LED (2) shows
17.2260
red as long as no radio signal is received
from the transmitter.
24.4690 The display (7) shortly shows
the transmission channel adjusted and a
symbol indicating the current charging sta-
tus of the (rechargeable) batteries in sever -
al steps (→ fig. 2). The display background
illumination will be extinguished if no button
is pressed on the receiver within 5 seconds.
3) Adjust the transmission channel for the
receiver and the corresponding transmitter
(→ chapter 5.1 "Adjusting the channel").
4) When the transmitter is switched on and
set to the same channel as the receiver,
the LED (2) will change from red to green
to indicate that a radio signal is received.
5) With the control VOL. (3), adjust the de -
sired volume for the earphone.
When the receiver is connected to an
amplifier system, the switch (4) allows to
adjust the level of the signal fed to the am-
plifier in three steps (HI, MID, LOW): If the
sound reproduced via the system is too
low, increase the level; if the sound repro-
duced is too high or if it is distorted, select
a lower step.
6) The receiver can be fastened to your
clothes via its belt clip (9).
7) After operation, turn back the control VOL.
(3) in counter-clockwise direction until the
receiver is switched off. The display (7) will
shortly show
, then
before it is extinguished.