Publicité
User Manual
Introduction
Thank you for purchasing the LINDY HDMI 2.0b 18G Repeater. This product has been designed to provide
trouble free, reliable operation. It benefits from both a LINDY 2 year warranty and free lifetime technical
support. To ensure correct use, please read this manual carefully and retain it for future reference.
The LINDY HDMI 2.0b 18G Repeater allows 4K Ultra HD 60Hz YUV 4:4:4 video signals to be extended
by connecting multiple HDMI cables together. To reach even longer distances multiple Repeaters may be
cascaded up to 10 layers.
Package Contents
HDMI 2.0b 18G Repeater
This manual
Features
HDMI 2.0b, HDCP (1.4 & 2.2) and HDR10 compatible
Maximum Input/Output Cable lengths (using LINDY Gold 24AWG Cable):
o 17.8G 4K Resolutions: 60Hz 4:4:4 8bit / 60Hz 4:2:2 12bit 10m In/10m Out
o 13.4G 4K Resolutions: 60Hz 4:2:0 12bit / 30Hz 4:4:4 12bit 15m In/10m Out
o 8.9G 4K Resolutions: 60Hz 4:2:0 8bit, 30Hz 4:4:4 8bit / 4:2:2 12bit 20m In/20m Out
Cascade up to 10 layers (requires external power, not included)
CEC pass-through
Operation
To achieve the stated distances, you must use high quality 24AWG HDMI Cables, such as the LINDY Gold
HDMI range. Using lower quality cables as well as adjusting the resolution, refresh rate, colour space and
colour depth will alter the possible distances.
Connect your HDMI source to the extender's input port
Connect your monitor to the extenders output port
Longer lengths may be possible when using lower resolutions such as Full HD 1080p
Next to the HDMI input port of the Repeater is a Status LED, this will light red when sufficient power is
provided and then turn green when cables are securely connected to the input and output. Finally the LED
will turn orange when a HDMI signal is detected.
If you are using multiple units then you must observe the maximum cable distances stated above between
each Repeater. In addition you must attach a 5V DC >500mA power supply or USB DC cable with a
3.5/1.35 barrel to each of the cascaded Repeaters.
Troubleshooting
Picture is not showing, or the picture flickers:
Check the status LED colour, if the LED does not light up red when first connected then attach a 5V
DC >500mA power supply or USB DC cable with a 3.5/1.35mm barrel
Use shorter lengths of cable or higher quality cables
Use high Quality LINDY GOLD cables, make sure connectors are well seated
Reduce the resolution, colour space or colour depth
On-board or cheap/low quality graphics cards can reduce cable length to the Repeater by up to 50%
For any other problems please contact LINDY technical support.
English
Publicité
