Setup; Ac Power; Mounting; Orientation - Chauvet DJ Obey 70 Manuel De L'utilisateur

3. Setup

AC Power

Mounting

Orientation

Rigging

Product
Addressing
Obey 70 User Manual Rev. 7
This product requires an external power supply, which is included. The included
power supply is rated for 100–240 VAC, 50/60 Hz, 500 mA max. Before powering on
the unit, make sure the line voltage to which you are connecting it is within the range
of accepted voltages listed on the label affixed to the product or refer to the
Technical Specifications. The listed current rating indicates average current draw
under normal conditions.
Always connect the fixture to a grounded circuit. Never connect the fixture
•
to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or
dimmer channel is used only as a 0 to 100% switch.
To eliminate wear and improve its lifespan, during periods of non-use
•
completely disconnect from power via breaker or by unplugging it.
Before mounting the product, read and follow the safety recommendations indicated
in the Safety Notes.
The Obey 70 may be mounted in any position; make sure adequate ventilation is
provided around the product.
Choose a location for the product that gives easy access for maintenance and
•
programming.
Make sure that the structure or surface onto which you are mounting the product
•
can support the product's weight (see Technical Information).
When rigging the product onto a truss, you should use a mounting clamp of
•
appropriate weight capacity and a safety cable.
The Obey 70 can control up to 12 separate fixtures. Each fixture must be set to
predetermined DMX addresses. Please see the chart below for the DMX starting
addresses of each of the 12 fixtures.
DIP
Product Address
switch
1 1 1
2 33 1,6
3 65 1,7
4 97 1,6,7
DIP
Product Address
switch
5 129 1,8
6 161 1,6,8
7 193 1,7,8
8 225 1,6,7,8
DIP
Product Address
switch
9 257 1,9
10 289 1,6,9
11 321 1,7,9
12 353 1,6,7,9
Page 11 of 69