Commissioning - Conrad 85 79 07 Notice D'emploi

Switching plus connection (reversing light)
Determine the correct line for the reversing lamp with the reverse gear engaged and the ignition on. The
light and direction indicators should be off. Once you have found the right line, switch off the ignition
again.
- Connect the red plus line of the PWR connection cable (5) to the plus contact of the reversing light.
- The black minus line of the PWR connection cable (5) must be connected to earth (car body).
- Connect the small white plug of the PWR connection cable (5) to the socket „PWR" at the control unit
(1).
- Connect the red plus line of the camera connection cable (12) to the plus contact of the reversing
light.
- The black minus line of the connection cable (12) must be connected to earth (car body).
Final inspection and adjusting the camera
Check the wiring again. Take your vehicle electronics in operation again. The monitor switches on at ini-
tial commissioning. The camera signal is sent by radio to the monitor (11) by the control unit (1).
Engage the reverse gear with the ignition switched on. The reversing system switches on automatically
after a brief time and is ready for use. The monitor shows the camera image. If an obstacle is recognised
already, distance and direction are displayed as well.
Turn the camera at the tail of the vehicle into the correct horizontal position. Screw the camera tight with
the attachment rings. For slanted surfaces, the metal spacer rings at the camera can be moved against
each other to balance out unevenness.
Tighten the knurled screw at the camera.

Commissioning

The reversing video system consists of two connected systems. The reversing mirror with integrated
monitor and the ultrasound reversing system.
With the reverse gear engaged, the ultrasound reversing system and the camera are activated. The
camera sends the images to the colour monitor integrated in the rear-view mirror.
If an obstacle is recognised, distance and direction are displayed on the monitor as well.
Test the system before first use to get familiar with the displays and signals.
Only switch on the ignition (board voltage supply) and then engage the reverse gear. The monitor shows
not only the sensor data but also the rear image.
27