Preparation; Installation - Conrad 85 79 07 Notice D'emploi

Preparation

Use of four ultrasound sensors makes it possi-
ble to monitor almost the entire reversing range
without any gaps. The sensors must be installed
evenly spaced along the vehicle width.
The figure shows the sensor areas in two per-
spectives.

Installation

To be able to install the sensors, you need a drill to drill the required holes in the bumper.
Carefully mark the hole positions before drilling.
Observe that the sensor angle is not impaired
by vehicle parts. This would cause malfunction.
The ultrasound sensors must be installed evenly
spaced along the vehicle width. The distance
between the sensors must not exceed 30 - 40
cm.
The assembly height should be in the range
between 50 - 80 cm.
Install the camera centrally in the middle to
enable the best view angle.
Drill attachment holes
When drilling, observe the safety infor-
mation of the drill. Observe that no lines
and cables are damaged that are locat-
ed in the drilling area.
Drill the holes for the four ultrasound sensors
with the included 21mm drill and the opening for
the camera with the 28 mm drill.
Deburr the holes after drilling with a file or a sharp blade.
23