Conrad 85 79 07 Notice D'emploi page 24

Inserting ultrasound sensors and camera
The ultrasound sensors always have to be in-
stalledhorizontally. Otherwise, wrong measure-
ments may result. Push the sensors into the
openings in the correct order until they are flush
with the bumper. Loosen the knurled screw at the
camera and adjust the camera to the bumper
with the metal spacer rings (8) if required. Do not screw the camera tight yet, since its viewing angle still
has to be adjusted.
Ensure that the ultrasound sensors are connected in the correct order. Start with sensor A at
the rear left (also see figure in chapter „Installation"). If the order is changed, the direction align-
ment in the display (11) is not correct.
Placing lines and components
Guide the connection lines of the ultrasound sensors through the
bumper to the trunk opening from the outside. Carefully place the
lines inwards so that no moisture can enter the car.
Attach the control unit (1) with the included adhesive pad. A suit-
able position is the side wall in the water-protected trunk close to a
reversing light. Observe that the connection lines of the sensors
can reach the control unit (1).
Place the connection lines of the sensors according to the connec-
tion sketch in chapter „Connection".
Attach the warning buzzer (3) with the included adhesive pad as
well. For this, remove the protective paper from the adhesive pad.
Find the ideal position for attachment of the warning buzzer. The
buzzer volume may be different depending on installation. A suit-
able position is, e.g., installation on the rear deposit or trunk cover.
The adhesive point must be perfectly free of dust and
grease. Do not use the glue below 5 °C, because this would not lead to reliable bonding. When
placing the lines in door pillars, etc., ensure that you do not impair or damage any safety-rele-
vant devices (e.g. side airbags).
24