Publicité
Les langues disponibles
Les langues disponibles
station and insert (2) AAA batteries according to the
polarity markings. Replace the compartment door;
5. Press the °F /°C button at the back of the base station
EN
to display the temperature in °F or °C.
Note:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechar-
geable (nickel cadmium) batteries.
For maximum performance in normal conditions we
recommend using good quality alkaline batteries.
If the battery power is low, there will be low battery icon
showing on the base station display.
Synchronize Remote Sensors with The Base
Station
Please note: each time the batteries (inserted into either
base station or remote sensor) are replaced or base
-40-
station/remote sensor lost
follow the below synchronization process to pair and
re-connect the base station and remote sensor:
1. Position the remote sensor near the base station;
2. Once the batteries are installed in the base station,
the RF signal icon . (located on the upper left of the
base station display) will flash for 3 minutes, indica-
ting that the base station is in synchronization mode:
it is waiting for remote sensors to be registered.
3. If 3 minutes have passed after the batteries were
installed in the base station and the RF signal Icon is
no longer flashing, press and hold the CHANNEL/
SYNC button on the back of the base station for 3-4
seconds until the RF signal icon is flashing again to
set it back in synchronization mode;
4. Install the batteries in the remote sensor and wait for
a moment or just press either the TX or RESET button
connection, make sure to
-41-
EN
Publicité
