ThermoPro TP-60S Manuel D'utilisation page 20

1. TX LED
2. Wall hanging hole
3. RESET
EN
4. TX
1. Battery Compartment: Holds 2 X AAA batteries to
power the unit.
2. Rain-proof and wall-mounted
3. Outdoor Temperature range: -58° ~158°F (-50°C
~70°C).
4. Humidity range: 10% ~ 99%.
Buttons
CHANNEL Selector (1,2,3): Slide to set Channel 1,2
or 3.
RESET: Press once to reset the remote sensor.
TX: Press to send temperature/humidity data to the
receiver manually.
5. Channel 1.2.3
6. 2*AAA battery
7. Sensor detection port
design.
-38-
Battery Installation and Setup
1. Open the battery compartment of the remote sensor
as below Figure;
2. Slide the channel selector switch inside the battery
compartment to your desired channel. For the first
remote you may select any channel, for additional
remotes select any unused channel;
3. Insert (2) AAA batteries according to the polarity
markings. Replace the battery compartment cover;
4. Open the battery compartment at the back of the base
-39-
EN