Meec tools 012588 Mode D'emploi page 23

WARNING!
The actual vibration and noise level when using
tools may differ from the specified maximum
value, depending on how the tool is used
and the material. It is therefore necessary to
determine which safety precautions are required
to protect the user, based on an estimate of
exposure in actual operating conditions (taking
into account all stages of the work cycle, e.g. the
time when the tool is switched off and when it is
idling, in addition to the start-up time).
DESCRIPTION
1. Chuck 1/4"
2. LED light
3. Right/left drive selector
4. Power switch
5. Battery compartment
FIG. 1
USE
CHARGING THE BATTERY
• The battery must be fully charged before
using it for the first time. Otherwise the
battery will not achieve its full capacity.
• Make sure that the battery is the right
way round when putting it in the charger.
Do not press too hard when inserting
the battery.
• Remove the battery from the charger after
1 hour. Unplug the charger from the
mains before removing the battery from
the charger.
IMPORTANT:
Only use the supplied charger to charge the
battery.
INSERTING/REMOVING THE
BATTERY
1. The battery is inserted in the tool by
pushing it into the battery compartment
slot. The battery should snap fully in place
so that the clips lock.
2. Remove the battery by pressing the clips
and pulling out the battery.
START/SWITCH OFF
1. Use the power switch to start the power
tool and keep it pressed to run the tool.
2. Increase the speed by pressing the power
switch. The more the power switch is
pressed, the faster the speed.
3. Switch off the tool by releasing the power
switch.
RIGHT/LEFT DRIVE
Use the drive selector to switch between
clockwise rotation and anticlockwise rotation.
When the drive selector is in the middle
position the power switch is locked and cannot
be pressed. Before putting away the tool you
should always put the drive selector in the
middle position so that the tool cannot be
started by mistake.
NOTE:
The tool must have stopped before the drive
selector for right/left drive can be used.
Otherwise you could damage the tool.
EN
23