SOLAC CP7304 Mode D'emploi page 10

sharp. Be careful and avoid
direct contact with the blades'
cutting edges.
- Recharge the battery/ies only
with the charger supplied by
the manufacturer. A charger
that is suitable for one type of
battery may cause explosion
or fire hazard when used with
other battery/ies.
CHARGING THE BATTERY
- Caution: A new battery is
not fully charged and must
therefore be charged before
the appliance is used for the
first time.
- Charge the battery at an
atmospheric temperature of
between 4 and 40ºC.
- Plug the charger (J) into the
mains.
- The first charging takes appro-
ximately 10 to 12 hours and
subsequent chargings will take
about 8 hours. Never attempt
to over-charge the batteries.
- Connect the charger (J) to
the jack using the socket on
the appliance. The socket is
located at the lower/back part
of the appliance.
- The pilot light will come on to
indicate that the charger is
charging the battery.
- When the battery is charged
disconnect the charger from
the mains supply.
- NB: For a long battery life,
it is advisable to charge the
battery, only, when it has run
out completely.
INSTRUCTIONS
FOR USE
BEFORE USE:
- Before using this product for
the first time, it is important to
make a full charge of batteries.
- Prepare the appliance accor-
ding to the function you wish
to use:
INSERTION OF COMB GUIDE:
- Take the comb guide for
both ends and insert in the
guidelines at the sides of the
appliance until it fits properly
(Fig.1).
- To extract the comb guide, just
pull out.
USE:
- The appliance can be used by
using his batteries.
- Turn the appliance on, by
using the on/off switch.
- Select the desired cutting
height using the comb height
selector (G). Slide it and adjust
the height according to the
desired cutting length.