Publicité
PHONO
NOTED:
-
REMOVE THE STYLUS PROTECTOR.
BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM
-
REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS.
1.
TURN ON THE SYSTEM UNTIL THE " POWER LED " LIGHT UP
2.
SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE
RECORD TO BE PLAYED.
3.
PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED).
4.
LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE.
THE PLATTER WILL START TO ROTATE.
5.
PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6.
ADJUST THE VOLUME TO THE DESIRED LEVEL.
7.
AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT THE TONE ARM
FROM THE RECORD AND RETURN IT TO THE REST.
8.
TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK : AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST RACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH TO " OFF
" POSITION, THEN IT WILL RUN TO THE END OF THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN
OFF THE UNIT BY POWER BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO " ON " POSITION TO
STOP THE PLATTER ROTATE). THEN PUT BACK THE TONE ARM TO THE REST POSITION.
LINE OUT CONNECTION
YOU CAN CONNECT THE SYSTEM TO YOUR WHOLE HI-FI SYSTEM BY CONNECTING THE LINE OUT SOCKET
(10) TO THE AUXILIARY INPUT SOCKET WITH A RCA CABLE (NOT INCLUDED).
DO NOT DISCARD ELECTRICAL OR ELECTRONIC DEVICES IN THE GARBAGE, DISPOSE OF THEM
AT YOUR LOCAL WASTE COLLECTION POINT.
CERTAIN ELEMENTS CONTAINED WITHIN THESE DEVICES MAY BE HARMFUL TO YOUR HEALTH
AND THE ENVIRONMENT.
GB-2
Publicité
