EZiclean aqua ultimate Manuel De L'utilisateur page 12

Caring for your device
1.Cleaning the side brushes
If the side brushes are dirty, disassemble them and then wash them with clean water. Then make sure they are completely dry
before reinstalling them on the device. If they are damaged, replace them with new brushes.
Note : When changing the side brushes, match the "L" and "R" signs on the side brushes to the "L" and "R" signs on the robot.
Note : In order to ensure proper functioning of your device, it is recommended to change your consumables every 6 months.
2. Cleaning the dust container and filter
- Open the dust bin compartment and extract the bin.
- Check that the robot's suction duct is not blocked and clean it with a cloth.
- Open the dust container and empty it, then pass it underwater if necessary. Wait until it is completely dry before reinstalling it.
- Remove the filters by blowing on them and tapping them lightly. Do not wash them with water.
- Re-assemble the filter and prefilter well before inserting them into the dust bin to avoid any malfunction.
Note :It is advisable to clean the dust container at least once a week and the filters every 15 days.
Do not wash them with water. Then make sure they are properly reassembled to avoid damaging the robot.
3. Cleaning the water tank
- Remove the water tank from the robot and rinse it with clean water.
- Wait until it is completely dry before placing it on the robot.
4. Cleaning of microfibers
- Remove the microfibers and wash them with water or pass them through the machine.
- Dry them well flat.
Note :
Do not use microfibers that are too wet to prevent them from flooding the ground. This could cause the robot to slip during the
cleaning cycle and not function properly.
Use the water tank on hard floors only (parquet, tiles, marble and painted hard floor, etc.).
5. Cleaning of sensors and connectors
Use a clean, dry cloth to lightly wipe the sensors and connectors.
Here is their position below:
Charging connectors
Sensors Sensors
Charging
connectors