Environmental Conditions For Intended Use; Preparing To Use; Intelligent Automated Functions - Precision Lumina Max LED Manuel Utilisateur

1.2 Environmental conditions for intended use

Temperature range
Humidity range

2. PREPARING TO USE

Connect the power supply under the base of the docking station to a main electrical outlet. Place the
light in the dock and the battery will begin charging. This is indicated by a green light flashing.
3. THREE PROGRAM MODES
The Lumina Max is only intended for the polymerization of dental materials:
• 1 s time cycle is used for a layered build-up and/or bonding agents
• The 3s time cycle is used for the finishing layer and/or darker shades.
The Lumina Max light is used intermittently in one of three programs each with time settings of 1 or
3s. To see the program selected, press the two buttons at the same time and hold for 3s until a beep is
heard. The diode will flash the color of the program, green, orange or red.
To change the program, scroll using any button. Stop at the chosen program and wait for the beep. The
light will stay in the chosen mode until changed manually.

3.1 Intelligent Automated Functions

The Lumina Max is the first light with this new concept.
14
+10˚C a +40˚C
30% a 75%
The green program mode is the manual mode. Press the large button and the
unit will light for 3s. Press the small button and it will light for 1s.
In the orange program mode, pressing the large button will give you 3s of
light, a 0.5s pause, then again 3s of light. The small button 1s of light, a 0.5s
pause, then 1s of light. This mode is used for layered build-ups
when the composite restoration is wide enough to require two side by side
activations.
In the red program mode the large button will give you 3s+3s+3s+3s
continously, with 0,5s pause between each activation, until you press the
button again to stop it. The small button gives 1s+1s+1s+1s
continuously, with 0,5s pause between each activation, until you press the
button again to stop it. This mode is used for cementing brackets or veneers or
in any other situation where repetitive activations are required.
Atmospheric pressure
range
IP class
70kPa a 106kPa
(0.7 bar a 1.06 bar)
2X