Installation; Commissioning - oventrop BWM-C F Notice D'utilisation

Installation

Natural, bright light corresponds to about 200 Lux.
If the level of illumination is not high enough to charge the battery
via the solar cells, use the additional battery or an external power
supply.
4. Installation
ATTENTION
Damage to property due to humidity, draught or thermal
influences
f Do not install the product in the open.
f Install the product at a minimum distance of 1.2 m from heat
sources.
Two screws and two dowels for fixing are supplied with the movement
sensor "BWM-C F".
1. Remove the mounting plate from the sensor.
Install the movement sensor "BWM-C F" at a minimum distance of
16 cm from a wall.
2. Hold the mounting plate against the ceiling and mark two drill holes.
3. Drill the marked holes and insert the dowels into the bores.
4. Fix the mounting plate with the help of the screws and tighten them.
5. Push the wireless movement sensor "BWM-C F" onto the mounting
plate.
5.

Commissioning

The operating instructions of the receiver are to be observed.
1. Set the receiver (e.g. DDC, gateway) to the "teach in" mode.
2. Press the "teach in" and configuration button of the wireless movement
sensor "BWM-C F" (see illustr. 1 on page 22).
24
"BWM-C F"
115328080-V02.08.2018