Use Instructions; Important Parts - DeVilbiss 9100D Mode D'emploi

4
CAUTION– Federal (U.S.A.) law restricts this device to sale by or on the order of a physician.
This humidifier is intended for single-patient use only. The humidifier may be
cleaned and reused by the same person. It must not be used by more than one
person.
USE INSTRUCTIONS (FOR SINGLE-PATIENT USE)
This product is intended to be used with continuous positive airway pressure (CPAP), some
auto-adjusting CPAP devices, bilevel systems and non-invasive ventilation devices for the
treatment of Obstructive Sleep Apnea (OSA).
This product is not recommended for use with auto-adjusting CPAP systems that use
snoring for pressure adjustment. The humidifier is known to attenuate snoring,
which prevents the auto-adjusting CPAP from detecting most snoring.
This product should not be used with any external heat source not recommended
by Sunrise Medical.
IMPORTANT PARTS OF YOUR HUMIDIFIER (Figure 1)
The DeVilbiss Humidifier is supplied fully assembled. After removing the humidifier and tub-
ing from the packaging, inspect the chamber, o-ring seal and tubing for damage before
using. Prior to first use, the humidifier should be washed, using the Care and Cleaning
Instructions on page 6.
The DeVilbiss Model 9100D Humidifier will produce the following humidification levels at
the flow rate shown under ambient conditions of 72°F (22°C) and approximately 25% rela-
tive humidity.
9100D Humidification Output Performance (22°C, 25% R.H.)
At the extreme condition of minimum water level and dry ambient air (104°F/40°C, 5%
R.H), the DeVilbiss Humidifier will provide approximately 25% R.H. at the nasal mask.
A-9100
E n g l i s h

USE INSTRUCTIONS

Flow Rate (LPM)
U s e I n s t r u c t i o n s
4
3
2
5
Figure 1
The DeVilbiss Humidifier consists of the
following parts:
1. Chamber Lid
2. Chamber Base
3. O-Ring Seal (Shown assembled in
chamber base)
4. Slide Latch (6 latches)
5. 15"(38 cm)22 mm diameter connec-
tor tubing
1