Advanced Operation; Using The Flash; Using Direct Access Buttons; Changing Menu Options - Odys -Slim Z8 Manuel D'utilisation

5

Advanced operation

5.1

Using the flash

If there is not enough available light for your photo, the built-in flash can provide the
additional light required.
Switch the camera on and select the photo mode (single shot or self-timer
1
mode).
2 Press the right button
flash mode changes from "Auto" to "Always on" to "Off" each time you press the
button. The corresponding status symbol for the flash mode is shown in the
upper left corner of the LCD.
The flash is activated automatically when the light level is too low if the flash is
set to "Auto". When "Always on" is set the flash is used for every shot. When
"Off" is selected, the flash is deactivated. The flash only works in single shot
mode and self-timer mode. It does not work in burst and video mode.
When the flash is charging, the LCD will be shut down. And it will be light when
completed.
Please note that using the flash increases battery consumption.
5.2

Using direct access buttons

Selecting photography mode directly
In photography mode, you can access the "Single"
modes by pressing the left button
displayed at the top left of the LCD.
Selecting the resolution directly
In photography mode, the OK button can be used to select the resolution progressively.
The current resolution is displayed at the top left of the LCD.
Accessing the flash mode directly
You can set the flash to "Auto"
pressing the right button
The corresponding symbol is displayed on the LCD.
5.3

Changing menu options

ODYS SL IM Z8
once or repeatedly to set one of three flash modes. The
repeatedly. The corresponding symbol is
, "Always on"
in single shot and self-timer modes.
, "SelfTimer" and "Sequence"
or "Off" by
19