Steba ZP 3 Mode D'emploi page 12

Usage
∙ Wipe the appliance and the cones with a damp cloth. Take
care, that the appliance is not plugged in, as it could start
with a pressure on the juice cone.
∙ Place the carrier spindle on the motor part.
∙ Put the juice container on the motor base. The spout must be
placed at the opening.
∙ Put the sieve onto the juice container.
∙ Place the small juice cone onto the carrier spindle. For bigger
fruit, place the bigger juice cone on the small cone.
∙ The fruit shall be cut into halves.
∙ Put the fruit halves on the juice cone. By a slight pressure on
the lever-arm the juice cone rubs the juice out of the flesh. Do
not press too hard, in order not to scrape the white skin which
mostly tastes bitter.
∙ If you press too tight, the motor protection will react and the
device will stop. Continue working with light pressure.
∙ The juice is collected in the juice collector. When the spout is
moved downwards the juice will run out of the spout in a glass,
which must be placed beneath the spout before. Lift the spout
for collecting the juice again.
∙ It must be taken care, that the sieve gets not jammed.
∙ Never try to clean the sieve when the motor is running.
The juicer must be unplugged and the sieve should be
cleaned under running water.
∙ Citrus juice should be consumed quickly and stored in a metal
container.
12