Unibor E32 Mode D'emploi page 10

STARTING THE CUT
10
N.B. Safety strap and guards have been omitted from the photo' s .
• Plug the machine into the power socket and the red LED on
the electronic control panel will flash.
• To P
OWER
button Fig. 9
• To E
NERGISE THE
button - the yellow LED will light Fig. 10 .
RECHECK the pilot is still centred on the hole position -
energising the magnet can sometimes cause the unit to move
slightly from the centre mark, reposition if necessary.
• The magnet will hold on all ferrous materials from a
minimum of 6mm (1/4") thickness.
Fig. 9
STARTING THE CUT
• lower the safety guard.
ALWAYS
• S
TART THE MOTOR
- the green LED will light Fig. 11 .
• Wind the cutter gently down to the surface of the work
and apply light pressure until the cutter has made the initial
groove in the surface. Increase the pressure until the motor
is loaded Fig. 12.
• Maintain steady pressure throughout the rest of the cut.
Too much pressure will not speed the cut, it will reduce the
life of the cutter and may cause damage to the motor. If the
shavings become blue add more oil.
Fig. 10
• TO STOP THE MOTOR,
• If the cutter jams in the workpiece,
raise the cutter out of the workpiece before re-starting.
• If the power is interrupted during the cut, the machine must
be reset before the motor will restart.
• At the end of the cut, the slug will be ejected. Withdraw the
cutter from the work piece and stop the motor.
• To disengage the magnet, press and release the yellow button
- the magnet will not disengage immediately, there will be a
3 second delay before the magnet disengages along with a
continuous beep.
Incorrect start up or shut down sequence:-
• A single beep will be heard for all operations carried out in
Fig. 11
the correct sequence. A continuous beep will sound for any
incorrect sequence.
• Neither drill nor magnet can be operated until red power
button is activated.
• When the red power button is activated, the motor will not
run until the magnet is activated.
Fig. 12
(E
LECTRONIC PANEL
U M , press and release the red
P THE ACHINE
M , press and release the yellow
AGNET
by pressing and releasing the green button
&
PRESS RELEASE GREEN BUTTON
STOP THE MOTOR
)
.
and gently