Hoonved CAP 10 E Mode D'emploi page 30

ENGLISH
3) During rinsing, the boiler temperature is indicated
and the display LEDs light up in sequence;
4) For the last 20 sec. of the cycle, when the drainage
pump is in operation, the tank temperature is
displayed once again.
By pressing the START "ST" button again, a new
washing cycle will begin.
ATTENTION
We recommend that you replenish detergent used up
by washing fats or dispersed during rinsing every 4-5
complete cycles.
This machine guarantees rinsing at temperatures ideal
for hygienic purposes;
indeed, if this is not sufficient, the washing cycle is
automatically extended so as to provide the necessary
conditions for optimum rinsing at 85
The waiting time required to attain optimum tempera-
ture can extend to a maximum of 8 minutes.
2.1.e.2 Interrupting the cycle
1) It is possible to pause the washing cycle in case of
EMERGENCY, by opening the door;
the message "F1" will appear on the display;
normal operations will resume on closing the door.
2 ) The cycle will also be interrupted by SWITCHING
OFF the machine using the "IL" button.
3) On switching the machine back on, the LED
indicating the last cycle selected will light up, and the
alarm message "A1" will appear on the display;
this will disappear when a new cycle is begun.
At the end of the washing cycle, take out the basket
and shake it gently so as to remove the last drops left
on the washed items.
Allow items to dry and remove them from the basket
with clean hands.
Store all items on hygienic and completely stable
surfaces.
30
LC1 LC2 LC3 LC4
LC1 LC2 LC3 LC4
°
C.
Part 2: For the operator
2.1.f Self-washing and Draining
When you have finished washing, SWITCH OFF the
machine by pressing the "IL" button.
Having drained the machine and released the
overflow, close the tank-access door and keep press
the START "ST" buttonpressed for approx . 3 seconds
an then release it.
The self-washing and draining cycle will begin, and the
drainage pump will be activated (where fitted); the
message "C1" will appear on the display for 2 min., 20
sec.
2.1.g Manual Draining
It is possible to drain the water from the tank at any
time during the day, according to the waste
accumulated.
To carry out this operation, proceed as follows:
- SWITCH OFF the machine and release the overflow
allowing all the water to drain from the tank;
- Remove the tank filters(26) and clean;
Manual draining for machines with drainage pump
For machines fitted with a drainage pump it is
possible to empty the tank by carrying out the manual
draining cycle, during which only the drainage pump
remains active.
ATTENTION
This cycle can only be carried out by leaving the
machine SWITCHED ON and the tank full of water,
indipendently from the hood, which can be open or
closed.
Having released the overflow, press the "SD" or
CYCLE button for 5 sec.; the drainage cycle will
begin.
The message "C2" will appear on the display for 4
min., 20 sec.
ATTENTION
By pressing the "SD" or CYCLE button you can
interrupt the drainage cycle before the preset time
is up.
At the end of the cycle, restore the filters (26) (30)
and the overflow (27) to their respective positions.