Blumfeldt 10035216 Mode D'emploi page 31

CLEANING AND MAINTENANCE
To clean it is recommended to use cleaning products for glass and cloth.
Removing every time any pellet residuals inside the burner to avoid that the
pyrolysis doesn't occur correctly in the next ignition.
Every 2/3 usage of the heater, it is recommended a lubrication of the burner'
sliding guides, to avoid the malfunction of the system.
Glass tube cleaning :
1. It makes sure that there isn't flame and the heater is cold and off.
2. Open the heat diffuser door.
3. Lift upwards the glass to bring it out from the base and extract it from the
grate.
4. Spray inside with cleaning products.
5. In the tube inserts a big quantity of kitchen towel or a dry cloth.
6. Help yourself with a tube or a stick with a smaller diameter than the
tube's one and push the kitchen towel or the dry cloth until bring them
out on the other side of the tube.
7. In the event that the tube would have droplets of humidity or their
residues, having been outdoor, eliminate them with the use of common
glass cleaning product. Spray it on the tube and dry it carefully. for the
inner part of the tube you follow the instructions on the point 4.
8. After tube cleaning, you have to reposition the glass tube inclining
and reinserting it before with an upward movement and then with a
downward one until you reinsert it correctly in its place on the base of
the heater.
9. Close again the heat diffuser door.
To avoid that the dust of the combustion will form a crust and it makes the
tube or the glasses impossible to be clean, you have to perform the cleaning
after every combustion or at the latest two combustions.
Structure cleaning:
• Cleaning also the varnished parts with a soft cloth, water and mild soap.
• Cleaning carefully the ash of the heater as previously described in these
instructions.
FOR ANY OPERATIONS OF CLEANING IT IS RECOMMENDED TO NOT USE
ABRASIVE OR CORROSIVE PRODUCTS.
EN
31