Télécharger Imprimer la page

Blumfeldt 10035216 Mode D'emploi page 27

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INITIAL OPERATION
The initial operation should be performed completely outdoors and in the
absence of not- authorized persons in order to avoid any disturbances during
the execution of the following steps. Assure yourself that all advices in this
manual have been considered and that you have natural firelighters at your
disposal.
For the initial operation a usage of 3-4 kg of pellets is sufficient.
Loading and first firing up
1. Please open the front door of the base element.
2. Draw out the brazier.
3. Fill in 3-4 kg of pellets.
4. Place 2-3 pieces of a natural firelighter onto the pellets and light them.
(Remember that the use of inappropriate firelighters could lead to a
malfunctioning of the heater).
5. Cover the brazier with the dedicated flame reducer after being sure that
their combustion started well.
6. Insert the brazier in the base element of the heater again, lock the
door,end remove the key storing it in a safe place.
It will be necessary to wait for 10 minutes before that the flame starts to
come out from the glass tube.
Do not open the door of the base element during the combustion.
Let the heater to operate until the pellets in the burner have completely
burned, bearing in mind that after the diminishing of the flame the heater
emits heat for at least 2 hours respectively corresponding to the quantity of
pellets you have used.
Especially on the occasion of the first ignition or of those immediately
following it is considered normal the emission of whitish fumes and odours.
this can be also repeated, but gradually less intense, for some times, but it is
normal in the first heating of a new product.
Discharge at end combustion:
1. Open the front door of the base element.
2. Wearing the appropriated fireproof mitts remove the cover of the
collecting drawer underlying the brazier.
3. Keep wearing the fireproof mitts and open the brazier at its bottom end in
order to discharge the combustion residual in the drawer.
4. Clean the inside of the brazier, using the poker if necessary, removing any
residual pellets even if still burning.
5. Please check that the edges and the lower door are clean so to have a
perfect closing. Then close it.
EN
27

Publicité

loading

Ce manuel est également adapté pour:

10035217