ELSA LANCOM Business Manuel De L'utilisateur page 230

R54 Description of the menu options
a network that is known but is not currently available. The table is sorted by the network
numbers.
Network
00000001
00000002
00000010
00000081
LAN-filter-table The LAN filter table permits the selective filtering of routes that are 'learned' via the local
network. Filtered routes do not appear in the IPX-RIP table.
A LAN filter table for filtering routes in the range from 00001000 to 00001fff might, for
example, have the following appearance:
Start-net
00001000
WAN-filter- The WAN filter table permits the selective filtering of routes that are 'learned' via the
table
wide-area network. Filtered routes do not appear in the IPX-RIP table.
A WAN filter table for filtering routes in the range from 00002000 to 00002fff might, for
example, have the following appearance:
Start-net
00002000
Routes/FRM This parameter sets the maximum number of routes that can be included in a RIP frame.
The specified value originally defined by Novell is 50. Today, however, it is common
practice to pack a higher number of routes in each frame in order to reduce network
utilization. If all participating devices in the network support a higher number, this value
can be raised as high as 182.
Aging-minute(s) This option allows you to set the number of times the RIP table will be updated until an
entry in the RIP table ages, i.e. until the route recorded there is marked as 'not reachable
(down)'. You can enter a value from 1 to 60; the default value is 3.
ELSA LANCOM Business
Hops Tics Node-ID
0 1 00a05702000a
1 2 00608c70ab56
2 7 00A057020014
1 6 00a05702000b
End-net
00001fff
End-net
00002fff
Time Flags
0 local, direct
1 local
1 local, DOWN
0 remote, direct