Setup/Ipx-Module - ELSA LANCOM Business Manuel De L'utilisateur

When making settings for the fast-Ethernet operation, please note that the selected
transfer mode must also support the additional terminals.
When the system is switched off and on again, the last port to be selected remains
activated.
Node-ID This option allows you to display the router's own Ethernet address. The value displayed
here was set at the factory and cannot be changed. The Ethernet address is displayed
as a 12-digit hexadecimal value, with the first six digits '00a057' standing for an ELSA
device.
Spare-heap The spare heap blocks for the local network affect the number of buffers that are always
available for receiving frames from the local network. The default value is 10, which
ensures that, e.g., four Telnet sessions can be activated via the local network at any time.

Setup/IPX-module

This menu allows you to enter settings for the IPX module, particularly for the IPX router.
The menu has the following layout:
/IPX-module
Operating
IPX-router
LAN-config
WAN-config
RIP-config
SAP-config
Operating This option allows you to activate or deactivate the IPX module. In the default
configuration, the IPX module is activated.
Remote configuration via DOS/IPX and the IPX router can be used only if the IPX module
is activated. For local configuration via a LAN, the router does not have to be activated.
IPX-router This option allows you to activate or deactivate the IPX router. In the default
configuration, the IPX router is deactivated.
When the IPX router is activated, the IPX module is also activated. The IPX router can be
activated only if different, permissible network addresses are entered under LAN-
configuration and WAN-configuration.
Description of the menu options
IPX module (IPX router) settings
Activates or deactivates the IPX module.
Activates or deactivates the IPX router.
Settings for the LAN side
Settings for the WAN side
RIP settings
SAP settings
ELSA LANCOM Business
R49