Carrying Out The Blood Pressure Measurement - SilverCrest 297903 Mode D'emploi Et Consignes De Sécurité

Confirm your choice using the START / STOP button
or wait 3 seconds. Your choice will then be
8
saved automatically.
Carrying out the blood
pressure measurement
Place the cuff on your arm as previously described and
assume the position in which you wish to carry out the
measurement.
Switch on the blood pressure monitor using the START /
STOP button
After the full-screen display, the last measurement result saved
will be displayed. If no measurement has been saved, the de-
vice will display the value of „0".
The cuff will inflate automatically. The cuff air pressure is
released slowly. If a tendency towards high blood pressure
is detected, the cuff is pumped up once more increasing the
cuff pressure again. As soon as a pulse has been detected,
the pulse symbol
The measurement results for systolic pressure, diastolic pres-
sure and pulse will be displayed.
You can stop the measurement at any time by pressing
the START / STOP button
If the measurement has not been carried out correctly,
„Er_" will be displayed (see „Troubleshooting" also).
Repeat the measurement process in the event that this
happens.
The measurement result will be saved automatically.
22 GB/IE/NI
.
8
will be displayed.
8
.