Operation - American Hometec AHQ-T16 Guide D'installation Et D'utilisation

1. Set the desired water temperature by pressing power level "UP" or "DOWN"
button on the control panel. Turn the hot water faucet on all the way let
initial cold water in the pipe run out, you will get the hot water close to the
temperature you set. How close to the temperature you set depends on how
close you have installed the unit to the fixture. Regardless of varying incoming
water temperature, this unit will supply hot water at a constant temperature
that is close to the temperature you set (or factory default setting at 110°F if
you have not changed the default temperature setting), provided the hot
water application is within the unit's capacity.
2. Register the unit for warranty purposes at

Operation

The heater supplies hot water at a constant temperature when it is
operated within its designed capacity. The heater automatically adjusts
its power consumption to match the demand of hot water so that you
enjoy maximum energy savings.
Do not block the discharge of the pressure relief valve (if installed)
This unit is designed with safety features to protect against scalding. The
following required information is provided to the consumer:
WARNING! Hot water can produce 3
o o
140 F / 60 C and in 30 seconds at 130
The unit is not designed to withstand freezing temperatures during
standby. Attempting to operate the unit while frozen will cause
irreversible damage.
A flow rate of > 0.5 gpm is required to enable the unit. Continuous
operating at very low flows can result in damage to the heating
mechanism
The hottest water temperature from the unit is 125
temperature switch automatically disables the heating if the temperature
exceeds 125 F (52 C)
o o
11
www.americanhometec.com
rd
degree burns in 6 seconds at
o o
F / 54 C
F (52 C). An internal
o o