Connect Electrical - American Hometec AHQ-T16 Guide D'installation Et D'utilisation

Connect Electrical

Note: Only licensed professionals should open the cover panel of unit.
1. Connect the two load wires from each 40A circuit to the terminal block
connections labeled L1, L2. Tighten screws.
2. Connect the two Ground wires to terminal block G terminal and insure that
these are connected to the grounding block in the electrical service panel.
1) CAUTION: CONNECT ONLY TO A CIRCUIT PROTECTED BY A CLASS A
GROUND FAULT CIRCUIT INTERRUPTER.
2) USE COPPER CONDUCTORS ONLY.
3) CANADA: USE BONDING CONDUCTOR IN ACCORDANCE WITH THE
CANADIAN ELECTRICAL CODE, PART I. A green terminal (or a wire
connector marked "G", "GR", "GROUND", or "GROUNDING") is provided
with the control box. To reduce the risk of electric shock, connect this
terminal or connector to the grounding terminal of the electric service or
supply panel with a continuous copper wire in accordance with the
Canadian Electrical Code, Part I
CAUTION: Do not switch on power. This will be done during start up steps. Close unit.
Unit is now prepared for initial start up.
Figure 4: Internal Diagram
9