Getting Started - Furrion Aurora FDUP43CBR Manuel D'instructions

Getting Started

The Setup Wizard window appears only the
first time you turn on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or
cable connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
2. Use / / /
your desired settings.
Setup Wizard
Menu Language
Air/Cable
Cable System
Auto Scan
Move
to navigate and select
English
Air
Auto
Select
MENU Exit
Setup Wizard
or
Use
Menu
Language, then press
Language
English, French or Spanish.
or
Use
Air/Cable
then press
Cable.
or
Use
System, then press
Cable
Auto, STD, IRC or HRC.
System
NOTE: Only adjustable when "Air/
Cable" is set as "Cable" mode.
or
Use
Auto Scan
then press OK or
the channels available in your area.
NOTE: You may press MENU at any time to
exit the menu.
to highlight Menu
or to select
to highlight Air/Cable,
to select Air or
or
to highlight Cable
or to select
to highlight Auto Scan,
to start scanning all
19