Channel Settings - Furrion Aurora FDUP43CBR Manuel D'instructions

TV Settings

Channel Settings

1. Press MENU button, the setup window will appear on the screen.
2. Use or to highlight Channel mode.
3. Use or to highlight the item you would like to reset, then press
settings.
4. Press OK to confirm your selections or settings and enter the sub menus.
5. Press MENU to return to the previous menu or press EXIT at any time to exit the setting.
Note: For Cable or Satellite users with a set-top box, there is no need to run channel Auto Scan.
Connect your cable or satellite set top box to one of the available inputs on the TV for viewing.
Air/Cable Set the reception type.
Press
Auto Scan
sub menu.
Add or delete a channel in
Favorite
the favorite list.
Show or hide available
Show/Hide channels already in
memory.
Select a channel number
Channel No.
to be labeled
Allow custom labeling to
Channel Label
name or rename a channel
DTV Signal Dynamically display the DTV signal status.
30
Channel Menu
Press
●
Select Air when TV is connected to an indoor / outdoor antenna.
●
Select Cable if you subscribe to a pay television service WITHOUT a set top
box.
Cable System
or OK to enter
Start to Scan
Press
channel in the favorite list.
Press
channel.
Press
Press
to the next space. (Maximum of 7 characters)
or to select Air or Cable.
Press or to select Auto, STD, IRC or HRC.
(Only available when you select Cable as the reception type.)
Press or OK to start scanning available channels..
or to select a channel, then press
or to select a channel, then press
or to select a channel.
or to select each letter, number or character. Press
or to select the
or OK to add or delete the
or OK to show or hide the
or to skip