Troubleshooting - Furrion Aurora FDUP43CBR Manuel D'instructions

Troubleshooting

Problem
● Make sure the power cord is plugged in.
● Try another AC outlet.
TV does not
● Power is off, check fuse or circuit breaker.
operate
● Unplug unit for an hour, then plug it back in.
● Check the volume settings.
Normal
● Sound muted? Press MUTE button.
picture, but
● Try another channel.
no sound
● Check audio cable connections.
● Make sure the remote control is in range with no obstructions.
The remote
● Check the batteries.
control does
● Correct operating mode set: TV, VCR etc.
not work
● Station or Cable TV experiencing problems, tune to another station.
Poor sound or
● Check sound adjustments (Volume or Mute).
no sound
● Check for sources of possible interference.
● Station or Cable TV experiencing problems, tune to another station.
● Make sure channels are set into memory.
Poor picture
● Check antenna or Cable TV connections, adjust antenna.
or no picture
● Check for sources of possible interference.
● Check picture control adjustments.
● Ensure the antenna amplifier is turned on for Antenna TV.
● Adjust the antenna position to a stronger signal receiving angle.
● Check if the Antenna connection is tight to the TV.
Poor TV
● Check if there is power supplied to the Antenna distribution box.
reception
● Check if your incoming cable is connected to the correct cable / antenna
● Ensure the internal RV coax jump cable is connected to the correct port.
● Ensure antenna amp is turned off for cable signal.
● Check if incoming cable is connected correctly to RV.
● Ensure cable splitter box has power.
Poor Cable /
● Check if the incoming cable is connected to the correct cable / Satellite
Satellite TV
Reception
● Ensure the internal RV coax jump cable is connected to the correct port.
● Ensure Dish has no obstruction.
● Sleep Timer is set.
TV shuts off
● Power interrupted.
● Check video connections on both the TV and connected AV device.
Black and
white image
from the
connected AV
● Ensure all video cables are connected firmly.
device
wall connection inside the RV.
wall connection inside your RV.
Ensure the colors match between the connectors and sockets: green (Y),
blue (Pb/Cb) and red (Pr/Cr) for component connection, and yellow
(VIDEO) for composite connection.
Solution/Issue
33