Getting Started With Webos Tv; Initial Setup; Watching Tv Broadcasting - Furrion AURORA FDUB43CSA Manuel De L'utilisateur

NOTE: Improper use of batteries can result in a chemical leakage or explosion.
●
Use only the size and type of battery specified.
●
Danger of explosion if batteries are incorrectly replaced.
●
If the device is not to be used for a long period of time, remove the battery to
prevent damage or injury from possible battery leakage.
●
The batteries should not be exposed to excessive heat due to sunlight, fire or
other heat sources.

GETTING STARTED WITH WEBOS TV

Initial Setup

Press the button on the control panel or on the remote control to turn on the TV,
follow the on-screen instructions to finish the initial setup.

Watching TV Broadcasting

Your TV must be connected to an antenna/cable or a set-top box that can receive
broadcasting for broadcasting.
Prepare Live TV
Follow the steps below to finish an antenna/cable connection if your TV is not
connected to a broadcast antenna.
1. Connect the broadcast antenna/cable to the TV. You may also connect a piece
of equipment that can receive broadcasting such as a set-top box instead of the
antenna/cable.
2. Launch /
Control Settings.
3. Start the /
only channels being broadcast.
Enjoy Live TV
Press the /LIST button on the remote control. Use the
the desired channel then press
/ Connection / Device Connection Settings / Universal
/ Channels Channel / Tuning / Auto Tuning. Finds and adds
button to select the channel.
- 18 -
buttons to move to
CCD-0005519 Rev: 03-22-22