Programming Via Ets Software - Helios KWL-KNX Notice De Montage Et D'utilisation

Installation and Operating Instructions
+
IMPORTANT
+
IMPORTANT
KNX/EIB Module KWL-KNX
KWL-KNX connection terminals
Terminal
ò
+24 V: Power supply 24 V DC
ù
A: RS 485 Bus
ä
B: RS 485 Bus
ë
GND: Ground
Wiring diagram SS-1076
KWL-
Komponenten KWL-EC ...
4 1 4 1
LAN
8
RJ-45 RJ-12 RJ-10
KWL EC ... easyControls
SS-1076 Nr. 85317 001 10.06.16

2 .2 Programming via ETS software

The ETS (Engineering Tool Software) is a manufacturer-independent software tool for planning and configuring
intelligent home and building control systems with the KNX system.
Software version ETS4 is required as a minimum, as otherwise the various datapoint types will not be
available!
The KWL EC ventilation unit must have software version 2 .03 as a minimum .
Upgrading takes place via the Helios control concept easyControls (see instructions no. 82237: Adjustment
and starting up – easyControls).
Using the web browser interface, press the button "Upgrade software now" in the "Initial Commissioning"
menu to upgrade versions. The upgrade involves the firmware on the motherboard, as well as the accessory
components (KWL-EM, KWL-BEC, KWL-CO 2 , KWL-VOC and KWL-FTF) and all page contents.
Fig .2
ù
ä
ò
ë
Helios-BUS
4
1
Analog
1 6 1 4 1
3
ü
Terminal
ö
+ : KNX/ EIB +
ü
- : KNX/ EIB -
Bauseits zu erstellen /
120 Ohm
Abschluss- To be supplied by others /
widerstand
Furnitures et réalisation
wenn letzter
Teilnehmer
KNX/EIB Modul
KWL-KNX
Art.Nr. 4275
Adresse intern Fest
+ -
KNX/EIB
Weitere Hinweise im
Komponenten - BUS- Plan
SS-1077
Übersicht easyControls
EN
Fig .3
Programming but-
ton incl. LED for
programming status
ö
par installateur
SS-1042-1045