Flex FX2471 Manuel De L'utilisateur page 9

WARNING
assembly, adjustments, or accessory
changes. Such preventive safety measures
reduce the risk of starting the tool accidentally.
TO ATTACH/DETACH BATTERY PACK
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool (Fig. 2).
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool
and that the latches snap into place properly.
Improper attachment of the battery pack can
cause damage to internal components.
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool (Fig. 3).
Always turn off the tool
WARNING
detaching of the battery pack.
INSTALLING AND REMOVING BIT
Use only spiral cutting bits with a 1/8" or 1/4"
shank.
WARNING
the collet nut without a bit installed.
When replacing bits, do not insert the
cutting flutes into the collet. This may result
in broken bits.
Always use the correct collet for the cutting
bit:
Use 1/8" collets for 1/8" cutting bit shanks.
Use 1/4" collets for 1/4" cutting bit
a. Remove the battery pack and remove the
wrench from the base of tool (Fig. 4).
Detach the battery pack
from the tool before any
before attaching or
Bits are sharp. Handle
with care. Never tighten
shanks.
ASSEMBLY
Fig. 2
Fig. 3
Fig. 4
-9-
1
2