Operating - Sportec 27053 Mode D'emploi

3.1.2
Search mode
3.1.3
Manual treatment
3.1.4
Treatment with
automatic timer
Apply the tip to the skin with light pressure - in the approximate area where
the acupuncture point should be located (see accompanying book). When you
begin searching, the audio signal will become brighter, and one or more LEDs
will light up on the display the closer you come to an acupuncture point. Search
for the point with the tip until the audio signal is at its brightest and the most
diodes are illuminated.
NOTE
Sometimes acupuncture points are located very close to one
another. In order to find the right point for the desired
treatment, always refer to the accompanying acupuncture
book or specialized literature.
Once you have found the acupuncture point, press the stimulation button
with your index finger and keep it depressed. The audio signal ceases and the
LED begins blinking; at the same time the first LED in display
tinuously. You are now treating the acupuncture point with the lowest electric
current (basic setting). If you wish to increase the intensity, it is recommended
to keep the tip on the acupuncture point and to change the intensity set-
ting (see also "Adjusting the intensity"). As soon as you release the button
the stimulation ceases and the device returns to search mode. Therefore you
yourself determine how long the electrical impulses are transmitted.
By means of an internal clock the MEDISANA ACS/ACP can be set for 30
seconds or 60 seconds of stimulation using button
until it is changed by pressing the button
In the basic setting, as soon as you turn on the device, the manual mode is
always activated first.
Before searching for the acupuncture point, set the desired time by pressing
the button : press once for 30 seconds, and press again for 60 seconds. The
LED displays the respective setting.
Search for the acupuncture point (see "Search mode") and briefly press the
stimulation button once. The LED
to keep the stimulation button
device on the acupuncture point with light pressure.
After the set time has expired the device returns to the search mode. Since the
time setting is retained, you can stimulate the point again for the same set time
by again briefly pressing the stimulation button

3 Operating

. The set time is retained
or until the device is switched off.
begins to blink. Since you do not have
depressed, you can comfortably hold the
.
GB
blinks con-
,
13