Fulbat Fulload 1000 Mode D'emploi page 3

ELECTRICAL PARTS
Delivered with:
• Input Connector: 2PIN plug.
• Output Cord: 4 feet with Quick Connector.
• Extend Cord: 2 feet with Crocodile Clips / Ring Terminals.
ENVIRONMENTAL CHARACTERISTICS
• Operating Temperature: 0 to 45° C.
• Storage Temperature: -25 to 85°C.
• Operating Humidity Range: 0 to 90% RH.
• Cooling: Passive / Natural.
TECHNICAL SPECIFICATIONS
Part number
Type
Approvals CE, NZS, SAA
Input voltage range
Input frequency
Output
Size (LxWxH) in mm
Weight
CHARGING INSTRUCTIONS
STEP 1 - Pre Charge Check & Electrolyte Level Check
• Check the Battery Electrolyte level (Not required on sealed & Main-
tenance Free Batteries). If necessary, remove the vent caps and
add distilled water so the levels are halfway between the upper and
lower fill lines.
• Check the Voltage Output Switch on the charger and make sure it's
on the correct voltage.
STEP 2 - Connecting the Battery charger to your Battery
• If the Battery is out of the vehicle:
- Connect the Red lead from the charger to the positive (+) battery
terminal.
- Connect the Black lead from the charger to the negative (-) battery
terminal.
FULBAT - www.fulbat.com
FULLOAD 1000
Automatic
UL, CUL
100-240V 120V
50/60Hz
1A @ 6/12V
100x65x36
0.4Kg
• If the Battery is still in the vehicle, determine if the vehicle is positively
(+) or negatively (-) earthed.
• If Negatively Earthed (Most Common) – FIRST Connect the Red (+)
battery charger lead to the positive (+) Battery post and then connect
the Black (-) battery charger lead to the vehicle's chassis and away
from the fuel line.
• If Negatively Earthed (Most Common) – FIRST Connect the Red (+)
battery charger lead to the positive (+) Battery post and then connect
the Black (-) battery charger lead to the vehicle's chassis and away
from the fuel line.
STEP 3 - Connect the battery charger to Mains Power (240Vac)
• Connect the battery charger to a 240VAC Mains Powered socket.
• Turn on the 240VAC Mains Power.
• The Charger will automatically start when AC power is connected
and switched on.
(Note: If the Fault Indicator LED illuminates Red, please check your
connections as it's likely that the Positive and Negative Leads are
reversed. Refer to Trouble Shooting Page for further information).
STEP 4 - Disconnecting the Battery charger from Battery
• If the Battery is out of the vehicle.
3
Red
Red BLACK
Connection in vehicle
(negatively earthed )
Black Red
Connection in vehicl e
(positively earthed)
BLACK