Care And Maintenance - Blackstone 1575 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Clean your Patio Oven regularly between uses and especially after extended periods of storage.
Ensure that the Patio Oven and its components are sufficiently cool before cleaning.
Never handle hot parts with unprotected hands.
In order to extend and maintain the life and condition of your Patio Oven, we strongly
recommend that the unit be covered when left outside for any length of time, especially
during the winter months.
Burner maintenance:
In most circumstances, burning off the residue after cooking will keep the burner clean. The burner
should be removed and cleaned annually or whenever heavy build-up is found in order to ensure that
there is no blockage (debris, insects) in either the burner portholes or venture tubes. Use pipe cleaner
to clear obstructions. A wire brush can be used to remove corrosion from the burner surfaces. When
refitting the burner, be careful to check that the venture tubes of the burner fit over the valve outlets.
Fittings and Storage:
Annual checking and tightening of metal fittings is recommended. Store the Patio Oven in a cool, dry
place. Cover the burners with aluminum foil in order to prevent insects or other debris from collecting
in the burner holes. If the Patio Oven is to be stored indoors, the LP gas tank must be disconnected
and left outside. The LP gas tank should always be stored outside, out of reach of children, and in a
dry, well-ventilated area away from any sources of heat or ignition.
PROBLEM
Burner will not light using the
ignition system.
Burner will not light with a
match.
Fire in burner tube has a low
flame or flashback (a hissing or
roaring noise may be heard)

CARE AND MAINTENANCE

TROUBLESHOOTING
POSSIBLE CAUSE
1. Bad battery.
2. LP gas cylinder is empty.
3. Faulty regulator.
4. Obstructions in burner.
5. Obstructions in gas jets or
gas hose.
6. Electrode wire is loose or
disconnected on electrode
or ignition unit.
7. Electrode or wire is
damaged, or pushbutton is
faulty.
1. LG gas cylinder is empty.
2. Faulty regulator.
3. Obstructions in burner.
4. Obstructions in gas jets or
gas hose.
1. LP gas cylinder is empty.
2. Obstructions in burner.
3. Obstructions in gas jets or
gas hose.
4. Windy conditions.
25
SOLUTION
1. Replace battery.
2. Replace with full cylinder.
3. Have the regulator checked
or replaced.
4. Clean burner.
5. Clean jets and gas hose.
6. Reconnect wire.
7. Change electrode and wire
change igniter.
1. Replace with full cylinder.
2. Have the regulator checked
or replaced.
3. Clean burner.
4. Clean jets and gas hose.
1. Use larger cylinder.
2. Clean burner.
3. Clean jets and gas hose.
4. Use Patio Oven in a more
sheltered position.

Publicité

Chapitres

Table des Matières
loading

Table des Matières