Teka GZC Série Manuel D'utilisation page 22

TYPE OF
HOT PLATE
Gas hob
ATTENTION!!!
If the power supply cable is replaced, the installer should leave the ground wire (B) longer than the
phase conductors (fig. 14) and comply with the recommendations given in paragraph 8.
In case of failure or cut in the cable, please move away
from the cable and do not touch it. Moreover the device
must be unplugged and not switched on. Call the nearest
authorized service center to fix the problem.
SERVICING
CABLE TYPES AND SECTIONS
TYPE OF
CABLE
H05 RR - F
WARNING: MAINTENANCE MUST ONLY BE
PERFORMED BY AUTHORISED PERSONS.
22
SINGLE - PHASE
POWER SUPPLY
2
Section 3 x 0,75 mm